KOSUN Vacuum degasser is a kind of special degasser for treating gas-immersed drilling fluid. - Shale Shaker,Shale shaker for sale,Dryer Shaker,Drying Shaker,Shale shaker manufacturers

KOSUN Vacuum degasser is a kind of special degasser for treating gas-immersed drilling fluid, and its degasser rate is up to 95%, which is suitable for all kinds of oil drilling solid control system. It plays an important role in restoring mud proportion, stabilizing mud viscosity and reducing drilling cost. At the same time, it can also be used as high power agitator.

KOSUN vacuum degasser used vacuum suction effect, cause negative pressure zone in a vacuum tank, mud under the action of atmospheric pressure, through the suction pipe into the hollow shaft of rotor, again by the window around the hollow shaft, the jet shaped into the tank wall, round due to the collision and separation effect, make the separation of drilling fluid into thin layer, immersed in the mud bubbles, gas evolution, through hollow pump suction and the separation of gas water separator, the exhaust pipe line to the safety of gas by the separator, the mud by the impeller discharge outside the tank. Since the main motor starts first and the impeller connected to the motor rotates at high speed, the mud can only enter the tank from the suction pipe, but not from the drainage pipe.

Operation rules of KOSUN vacuum degasser:

1. The installation of vacuum degasser requires smooth connection and reliable fastening, and the exhaust outlet is connected to the safe position outside the wellsite according to the well control requirements;

2. Before the vacuum degasser starts, the end of the drain pipe and suction pipe should be immersed in the mud at the same time, otherwise it will not work normally;

3. After the vacuum degasser is started, check the rotation direction of the motor, which should be consistent with the direction indicated by the arrow on the tank and pump. The water in the pump and the air-water separator must be drained;