Posted on

KOSUN liquid and gas separator is a special equipment for primary degassing of drilling fluid.

KOSUN liquid and gas separator is a special equipment for primary degassing of drilling fluid.

When the liquid and gas separator is not in use, clean the drilling fluid in the equipment and wash it with water. It is strictly forbidden to store the mud in the separator to prevent the mud from being used normally after it is dry and solid.

In general, the liquid and gas separator is installed on the side ground of the mud tank. The ground shall be horizontal, solid and equipped with anchor bolt pit.

When installation, use crane to lift the lifting lug on the top of the main body to lift vertically with the ground, slowly put it down, and then use steel wire rope from the upper part of the main body and the ground to take up, to ensure the main body and the ground is vertical, casting anchor bolts, fastening.

After installation, direct the exhaust line to a distance of 60-80m from the wellhead. The slurry inlet is connected with the rotary blowout preventer or throttle manifold, close the blowout butterfly valve, open the slurry outlet butterfly valve, and connect the pipe line to the mud tank.

When handling, remove the manifold, loosen the tension wire rope, use the crane to lift the top of the main body, loosen the anchor bolt to place the horizontal, at this time the ladder can be used as a handling support.

Features and advantages of KOSUN liquid and gas separator:

1. Separate and expel large amounts of free gases from your system, including toxic gases such as hydrogen sulfide;

2. The separated gas is discharged to the safe area of the wellsite through the discharge nozzle path for combustion;

3. The equipment is coated with anti-corrosion coating, which can extend the service life when dealing with corrosive gases.

Kosun- China Solids Control Leader&Drilling Waste Management Expert

Tel.: +86 29 87304914

Email: sales2@adkosun.com

Contact person: Jinbo Zheng

Contact person: Jinbo Zheng

http://www.kosun.com

http://www.kosuneco.com

Posted on

KOSUN vibration screen’s preparation before installation and daily maintenance

KOSUN vibration screen, divided into two types: elliptical motion shale shaker and linear motion shale shaker.

KOSUN elliptical motion shale shaker‘s elliptical movement, is a multi-layer number, efficient new type of shale shaker. Screening specifications, with a reliable structure, strong vibration force, high screening efficiency, small vibration noise, rugged, easy maintenance, safe use and other characteristics, this type of vibration screen is widely used in mining, building materials, transportation, energy, chemical industry, coal, metallurgy and other industries product classification. Strong processing capacity, high screening efficiency, reasonable technical parameters, high strength and stiffness of the mechanism, reliable operation, low noise, easy maintenance and other characteristics.

Preparation of the elliptical motion shale shaker before installation:

1. Check whether the motor label conforms to requirements;

2. Check the fasteners of the motor to prevent loosening;

3. Check whether the motor surface is damaged or deformed;

4. Check whether the rotation is flexible; if there is any abnormality, it should be excluded;

5. Check the power supply for lack of phase and run for 5 minutes without load.

Daily maintenance of theelliptical motion shale shaker:

1. Before starting: check whether the coarse mesh and fine mesh are damaged; Whether each group of beam rings is locked.

2. During starting: pay attention to whether there is any abnormal noise; Whether the current is stable; The vibrations are indistinguishable

3. After use: clean up immediately after each use.

4. Regular maintenance: check the fatigue and damage of coarse mesh, fine mesh and spring regularly, and check whether all parts of the shale shaker are damaged due to vibration. Lubricating oil must be added to the parts that need lubricating oil.

Kosun- China Solids Control Leader&Drilling Waste Management Expert

Tel.: +86 29 87304914

Email: sales2@adkosun.com

Contact person: Jinbo Zheng

Contact person: Jinbo Zheng

http://www.kosun.com

http://www.kosuneco.com

Posted on

KOSUN Vacuum degasser is a kind of special degasser for treating gas-immersed drilling fluid.

KOSUN Vacuum degasser is a kind of special degasser for treating gas-immersed drilling fluid, and its degasser rate is up to 95%, which is suitable for all kinds of oil drilling solid control system. It plays an important role in restoring mud proportion, stabilizing mud viscosity and reducing drilling cost. At the same time, it can also be used as high power agitator.

KOSUN vacuum degasser used vacuum suction effect, cause negative pressure zone in a vacuum tank, mud under the action of atmospheric pressure, through the suction pipe into the hollow shaft of rotor, again by the window around the hollow shaft, the jet shaped into the tank wall, round due to the collision and separation effect, make the separation of drilling fluid into thin layer, immersed in the mud bubbles, gas evolution, through hollow pump suction and the separation of gas water separator, the exhaust pipe line to the safety of gas by the separator, the mud by the impeller discharge outside the tank. Since the main motor starts first and the impeller connected to the motor rotates at high speed, the mud can only enter the tank from the suction pipe, but not from the drainage pipe.

Operation rules of KOSUN vacuum degasser:

1. The installation of vacuum degasser requires smooth connection and reliable fastening, and the exhaust outlet is connected to the safe position outside the wellsite according to the well control requirements;

2. Before the vacuum degasser starts, the end of the drain pipe and suction pipe should be immersed in the mud at the same time, otherwise it will not work normally;

3. After the vacuum degasser is started, check the rotation direction of the motor, which should be consistent with the direction indicated by the arrow on the tank and pump. The water in the pump and the air-water separator must be drained;

Kosun- China Solids Control Leader&Drilling Waste Management Expert

Tel.: +86 29 87304914

Email: sales2@adkosun.com

Contact person: Jinbo Zheng

Contact person: Jinbo Zheng

http://www.kosun.com

http://www.kosuneco.com