KOSUN Hi-G dryer shaker is used to recover the mud from drilling cuttings,so as to reduce the liquid/oil content drilling cuttings to as low as about 10%(w/w) and recover part of the drilling mud,so that the drilling cost can be reduced and the drilling waste volume can be cut down,for the purpose of reducing environmental pollution.The Hi-G dryer shaker suitable for both of WBM and OBM.
Features and Advantages of Hi-G dryer shaker:
G-force linear motion shaker with up to 8G vibrational force;
Make drilling cuttings more dryer;
Weir type feed box is more applicable to on-site process;
Fast drilling cuttings conveying speed and high handling capacity;
Screen frame tilt angle can be adjusted from -1° to 5°;
Rapid screen tensioning system ensures easy screen replacement;
Able to process heavier cutting loads.
Shaker feeder can be weir type and header box.
Hoop-strip screens can be PMD and PWP screen.
KOSUN Hi-G dryer shaker is used to recover cuttings from water-based or oil-based drilling fluids so as to lower the hydraulic proportion than 10% and significantly reduce the cost on waste discharge. It is proved to be particularly effective in recovering the oil-based mud cuttings.
Based on a combination of innovative design and highly advanced technology, KOSUN dryer shaker allow high throughput capacities to be achieved in a compact machine design. These features facilitate the layout and design of the complete dryer shaker for mud system. Shaker dimensions can be significantly reduced, ensuring low investment costs and saving space for other oil tools, especially for offshore drilling plant.(Editor:Kosun Lily.Wang)
Kosun- China Solids Control Leader&Drilling Waste Mangemnet Expert
Tel.: +86 29 87304914/86-13891934239
Contact person: Lily Wang
Drilling fluids Dryer shaker maintenance of is straightforward, while there are a considerable measure of basic disappointments additionally, we have to comprehend the normal deficiencies of boring liquid shaker and how to manage.
The following are some common problems faced concerning the drilling fluids dryer shaker:
The vibration engine pivot turn out to be gradually, and there is a heading warming:
This demonstrates the typical upkeep of the shale shaker was not done well, and the bearing is shy of greasing up oil, if the oil is recently included the reason will be oil quality issues or get too full, second rate oil make the bearing square so oil quality is very essential. The Hi-G dryer suitable for both of WBM and OBM
The poor screening nature of penetrating drilling fluids dryer shaker:
This issues may for the most part brought on by the mis operation, it might be the screen work blockage, fine grain size and increment of water substance in the strainer material, the sifter material layer is too thick, sustaining imbalance, etc. May both sides of the screen is not tight, in the event that it is an offbeat shaft vibration may the belt is too free, a time of invert revolution can be taken after the mechanical preparing is finished keeping in mind the end goal to enhance the nature of screening.
Shaft break of shaker box:
In the event that the screen box has been because of absence of inflexibility, flat level did not recognize, will bring about the shaft crack, on the off chance that it still in operation will likewise make the material stream peculiarities. There likewise might be uncalled for operation, that is the imbalanced sustaining is additionally one reason.
The shale shaker can’t begin or plentiful is too little:
Ought to check whether the aggregation of oil on the electrical machine is excessively, if so we ought to expel stores on the vibrating screen.